[Misc] Adjusting staples, how? Xerox 7845i, can’t find proper menu items...

[Miniman]

Hello everybody!

I try to adjust the staples in Xerox Workcenter 7845i + Professional Finisher (Booklet Maker). Now the staples are ~1,5 mm off the center.

But I can‘t find the ”Setup & Adjustment” or ”System Settings” from the menus :-(
Any idea? All help welcome!

Thanks in advance!

[Miniman]

Sorry for the two posts! Tells a lot about me...

[Milo Wilson]

I saw your post on Reddit. Didn't know it was a professional finisher. Here you go.

[Miniman]

I saw your post on Reddit. Didn't know it was a professional finisher. Here you go.

Thank you, Sir!
Prepare (You all) for more questions!
Thank you very much.

Meanwhile, here some photos.
IMG_8068.jpg IMG_8067.jpg

[Miniman]

I saw your post on Reddit. Didn't know it was a professional finisher. Here you go.

Okay, I read this manual as well as I’m able and have some question before even concidering to try something.
- Should there be any illustrations in this (ADJ 12.4) document? For example ”Figure 1. Staple Position”?
- Where do I find ADJ 12.2, ADJ 12.3 and ADJ 12.5?
- How do I enter ”UI Diagnostic Mode”?
I you have the time, please, let me know.

[Milo Wilson]

Where are you located?

[Miniman]

Where are you located?

Finland (Between Russia and Sweden).

[adriansto]

Finland (Between Russia and Sweden).

Search on net pdf service manual for 7855 and read how to adjust. Chapter 6 dc128.

[Miniman]

Search on net pdf service manual for 7855 and read how to adjust. Chapter 6 dc128.

Ok, thanks. So it’s the same for 7845 - thank you!
ps. I found the ”Xerox-WorkCentre-7855-Family-Service-Manual-66c7aaf1c263d”, downloaded it and it’s pure gold. Thanks!
Very clear and good instructions for the stapling and folding adjusments.