Xerox Workcenter 3220 scaner reads nothing after repairing broken line on cable ribbo

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • GIUBOSS
    replied
    Re: Xerox Workcenter 3220 scaner reads nothing after repairing broken line on cable r

    There may be micro breaks sensitive to some movements that are so difficult to measure.

    Leave a comment:


  • HOSTAKI
    replied
    Re: Xerox Workcenter 3220 scaner reads nothing after repairing broken line on cable r

    I think its clear that I fixed it and did continuity tests, as I cannot get a replacement somewhere

    Leave a comment:


  • GIUBOSS
    replied
    Re: Xerox Workcenter 3220 scaner reads nothing after repairing broken line on cable r

    Did you fix the flat cable or replace it... as it should be

    Leave a comment:


  • Xerox Workcenter 3220 scaner reads nothing after repairing broken line on cable ribbo



    continuity tests where done while I had the scanner moving manualy, to check if repair was done properly or it was anywhere miissing a bit as before.
    No mixed lines or anything .
    If I totaly unplug the cable and try to scan I get a completely black printout.
    I will also try to insulate the repair in case of short circuit somehow .. ? If that is the problem ?
Working...