Paper jams in registration rollers on arrival or 1/8" leading edge pass it.
Jams from tray 1, 2 and by pass at the same location.
Printer has 160k prints
The sensor actuator moves freely.
Check sensor with dc330 (071-103) shows low even when activated, value doesn't change with paper in or out but it sees a jam if I leave the paper inside after a jam.
Should I replace the registration unit?
Thanks
Jams from tray 1, 2 and by pass at the same location.
Printer has 160k prints
The sensor actuator moves freely.
Check sensor with dc330 (071-103) shows low even when activated, value doesn't change with paper in or out but it sees a jam if I leave the paper inside after a jam.
Should I replace the registration unit?
Thanks