Xerox Wide format Print system 510

[mdm]

Error message C1-05 load media. Media rolls back into tray.

any help

Thanks.

Regards
mdm

[AUS XEROID]

check the rego belt and make sure the geared end of the roll tube hasn't come unglued.

[mdm]

Thanks Aus,

I will belt and tube.

mdm

[mdm]

I check belt and tube and all seems to be good. Today I'm getting a different error E201.

Any help

mdm

[Tropix]

Re: Xerox Wide format Print system 510

Have you solved the problem of it?. I was going at the same C1-04
all belts is ok motor ok sensor ok


withdraw the paper and then coming back and keep track on paper of the pickup???


E2.-- This code indicates a problem in the paper path.

[mdm]

Re: Xerox Wide format Print system 510

Hey Tropix,

I had an E2 error a few months ago and it took me a while to figure it out.
The problem was a very small piece of paper over registration sensor, I had to remove cutter and toner,
then I was able to unscrew registration sensor and remove paper. Reassemble.

Hope this helps.

mdm

[Tropix]

Re: Xerox Wide format Print system 510

Hey Tropix,

I had an E2 error a few months ago and it took me a while to figure it out.
The problem was a very small piece of paper over registration sensor, I had to remove cutter and toner,
then I was able to unscrew registration sensor and remove paper. Reassemble.

Hope this helps.

mdm

i will try, but i have c1-04 error

Thanks

[Tropix]

Re: Xerox Wide format Print system 510

I solved the problem

there was a sensor cutter (broken cutter drive pulley (34T))

[AUS XEROID]

Re: Xerox Wide format Print system 510

Glad to see you sorted it, sorry i didn't get back to you earlier. That's a fairly common one do yourself a favor though if the big one has split the small one will do the same thing in the not too distant future. When you replace the little one make sure it's tight on the shaft, I've had a few lately that have a small amount of play on the shaft and it causes a small tag on the edge of prints because it doesn't cut cleanly. A small shim fixes it though.