Dc252 full colour black green tint

[Leonardbez]

Dc252 full colour black green tint

Hi i had the same problem.Black will have a green tint and normal colour print will get a magenta tint if you look close at the print.I printed 500 pg print from the machine .The first 80 prints looks good and then it change to the green/magenta tint on the full colour black blocks.My machine lost 4%of the magenta that made the change in colour.You can check it with a spectro meter.I replaced all PWB's, LVPS,mob sensors assy,all the drums ,dev,and dev tanks,reloaded software NO LUCK .Xerox then after 3 Months changed the machine .Never found the fault.

[adriansto]

Something like this:

Problem:


Machine will stop printing or copying , and display ,'Please wait , job will start automatically 'and after 30 secs approx , will restart and print a few more , then stop and the whole cycle starts again .


Cause:


If you watch the fuser lamp it will not glow , although the fuser rolls continue to rotate.The 'please wait ' message will eventually will go out , and the fuser lamps will come on and printing will continue . no fault codes were displayed or saved


Solution:


After swopping fuser CRU s , intilising the IOT ,and reloading s/ware, I changed the Power supply ,pt no 105E17900

[PopsAtWork]

Something like this:

Problem:


Machine will stop printing or copying , and display ,'Please wait , job will start automatically 'and after 30 secs approx , will restart and print a few more , then stop and the whole cycle starts again .

The "pause" I am refering to is for about 5 seconds and no change on the display. As the pause is occuring the machine is putting calibration patchs on the transfer belt. It does not seem to be fuser related.

[PopsAtWork]

Hi i had the same problem.Black will have a green tint and normal colour print will get a magenta tint if you look close at the print.I printed 500 pg print from the machine .The first 80 prints looks good and then it change to the green/magenta tint on the full colour black blocks.My machine lost 4%of the magenta that made the change in colour.You can check it with a spectro meter.I replaced all PWB's, LVPS,mob sensors assy,all the drums ,dev,and dev tanks,reloaded software NO LUCK .Xerox then after 3 Months changed the machine .Never found the fault.

I think you may have been experiencing the same issue I am having. I was getting excited about finding a solution, that is until I got to the part about replacing the machine. As of today the machine is running. Replacing the MCU will get it working for a few weeks but it is going to fail again. This has been going on for months now. I have a replacement machine ready for when it does. I was really hoping to avoid replacing the machine. All in all that may be my only fix for this customer.