DC 250 toner density measurements

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • savedsoul
    Technician
    • Jul 2009
    • 49
    #1

    DC 250 toner density measurements

    Hi all,

    I keep having to reset the toner density measurements to within the 25+- range everyday. Isn't it supposed to be stable. What could be the problem. I am also having too much magenta on prints and I cant calibrate I keep getting an error message Anyone know what I should do?
    Tags: 250, atc, calibrate, density, error, error message, hi all, magenta, measurements, message, prints, reset, toner
    • kalindd
      Trusted Tech

      100+ Posts
      • Jun 2008
      • 192
      #2
      Hi there I just saw you question. It's over 3 week but if you have not fixed it here are some suggestions.
      Your developer is old, this may be the reason for this. What's the count? Is the ATC sensor setup correct?
      Can you make a pic and post it here of Procon On table after you hit the start button? I want to see those numbers. For example ATC amplitude should be more than 50 if it is lower may be developer needs to be replaced.
      Anyway, just post that pic and I will help you.

        Comment

        • oxident
          Technician
          Site Contributor
          50+ Posts
          • Apr 2008
          • 74
          #3
          Originally posted by savedsoul
          Hi all,

          I keep having to reset the toner density measurements to within the 25+- range everyday. Isn't it supposed to be stable. What could be the problem. I am also having too much magenta on prints and I cant calibrate I keep getting an error message Anyone know what I should do?
          Just as a side question: How do you measure (and reset) the density?

            Comment

            Previous template Next
            Working...