Xerox dc 12 fiery problem

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • thuo
    Trusted Tech

    100+ Posts
    • Feb 2008
    • 155
    #1

    Xerox dc 12 fiery problem

    I HAVE A DC12 FIERY .FIERY COMING TO READY MODE I CAN PRINT THE CONFIGURATION PAGES BUT WHEN I TRY TO SET UP NETWORK CONFIGURATIONS i.e I.P, SUB NETMASK,PORT AND THE REST THEN RESTART THE FIERY THE CONFIGURATIONS ARE NOT STORED. I AM NOT AN EXPERT IN XEROX .REQUESTING FOR YOUR ASSISTANCE ON CONFIGURATION OF THIS FIERY TO PRINT ON NETWORK.
    Thanks
    Tags: dc12, fiery, mode, network, pages, print, set, work, xerox
    • bojans
      Service Manager

      Site Contributor
      1,000+ Posts
      • Feb 2008
      • 1313
      #2
      Stupid question>
      Did you go to Save changes at the end of setup?

        Comment

        • philip1davies
          Technician
          • Feb 2011
          • 23
          #3
          How old is the fiery ?
          If old maybe motherboard battery ?

            Comment

            • thuo
              Trusted Tech

              100+ Posts
              • Feb 2008
              • 155
              #4
              FIERY

              Originally posted by bojans
              Stupid question>
              Did you go to Save changes at the end of setup?
              hi sir,
              I think if according to your wisdom the request was stupid .you should not have wastwd your precious time answering.

                Comment

                Previous template Next
                Working...