WC 7655 Fuser Nip Sensor

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • ZeusGT
    replied
    Re: WC 7655 Fuser Nip Sensor

    Flash, you are a life saver! Thank you so much!

    Leave a comment:


  • Flash
    replied
    Re: WC 7655 Fuser Nip Sensor

    On the 4110 the nip sensor is located on the lower fuser frame on the exit side toward the back side. The sensor is not spared on the 7665. You have to replace the fuser. The nip problem on the 4110 is probably a worn out bearing in the fuser/exit drive section.

    Leave a comment:


  • ZeusGT
    replied
    Re: WC 7655 Fuser Nip Sensor

    Hey flash,

    where exactly is the fuser nip sensor? I'm having the same problem on a 4110 and I was curious where the nip sensor is on the 4110. Would you happen to have any printouts or screen shots of the RAP to diagnose this problem? I would pay you for it if you want.

    Leave a comment:


  • Flash
    replied
    Re: WC 7655 Fuser Nip Sensor

    Did you try another fuser? Also check for a piece of paper jammed in the connector where the fuser slides into

    Leave a comment:


  • Percy4th
    Guest started a topic WC 7655 Fuser Nip Sensor

    WC 7655 Fuser Nip Sensor

    Hi, we have a WC 7655 that is out of contract. We are getting a Fuser Nip error (I think it is 010-321). I have been advised to check the fuser nip sensor but have no idea where it is. Any help locating it would be apreciated.

    Chris
Working...