Phaser 7760 alignment problem

[houly]

Hello all,
I need your help to solve this problem on my Phaser 7760 :
When I print a color text, the color doesn't not overlap exactly, what can I do to rectify it ?
All RegiCon adjustment tests were passed with only 1 to 4 clicks for adjustments... so what can I do ? do you have any idea ?

Here is a print example of the problem :
840881IMG0092.jpg

Thanks a lot for your help.

[Jaws]

Re: Phaser 7760 alignment problem

I suggest a new transfer belt.

[houly]

Re: Phaser 7760 alignment problem

Hello Jaws,
Thanks for your reply. Well do you mean that I need to change the accumulator belt ? ( see : http://download.support.xerox.com/pu...upplies_en.pdf page 7)

regards

PS : I forget to mention that the printer counter is about 130 000 pages.

[Jaws]

Re: Phaser 7760 alignment problem

Yes, I was referring to accumulator belt. I had a machine that I was able to get aligned but after a few prints it would be misaligned. Suggested they buy a new machine. I can not promise it will fix your problem.

[landspeeder]

Re: Phaser 7760 alignment problem

its the mirrors being out...turn all screws until they cant turn any further then go to the other end and count the clicks...then divide the total clicks and go to the middle..then run the test..and adjust from that point...it can be a challange but you will get it.

[houly]

Re: Phaser 7760 alignment problem

Hello landspeeder,
Thanks a lot for your reply.
I'm going to test it and tell you if it works... I hope it will be the solution !
thanks again