If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Machine error48 - Weak connection of the head flat cables. Head flat cables or carriage- head flat cable broken or not connected
-Correct the connection of the head flat cables.
-Replace the carriage PCB ASSY.
-Replace the head/carriage unit.
-Replace the main PCB.
The encoder strip is the thin plastic sheet that runs parallel to the shaft. There is a sensor on the carriage that reads the vertical lines on the strip to obtain the position of the carriage.
Comment