IR3100CN Show " Remove the paper from the output tray"

[phollawat Chaimoonchuen]

I have problem about Canon IR-3100CN.
1. It`s show " Remove the paper from the output tray". I check the paper all output tray, no have paper.
2. How, I want adjust color in correct.

Please help me.

Wat

[smiley]

do your machne has finisher?

[phollawat Chaimoonchuen]

do your machne has finisher?

Yes, I have.

[phollawat Chaimoonchuen]

Yes, I have.

Sory! No have

[Oze]

The buffer pass unit is unplugged.
Did you just purchase the machine?
If so then it DID have a finisher at some stage but they removed the buffer pass unit and forgot to change the setting under "ACC" in SERVICE MODE.

[phollawat Chaimoonchuen]

The buffer pass unit is unplugged.
Did you just purchase the machine?
If so then it DID have a finisher at some stage but they removed the buffer pass unit and forgot to change the setting under "ACC" in SERVICE MODE.

Please tell me step by step again.
Thank You.

[br21]

I've got same problem in same machine.
It probalbly was machine with finisher unit some time ago, but currently is without finisher, ACC in service mode OUT-TRAY set "0", surely no paper stuck, and constantly same information "remove..."
where to look for solution?

[Oze]

Has the machine been working ok up til now..or did you only just get it?

[Guest]

I've got same problem in same machine.
It probably was machine with finisher unit some time ago, but currently is without finisher, ACC in service mode OUT-TRAY set "0", surely no paper stuck, and constantly same information "remove..."
where to look for solution?

Do the following :
1. Enter Service mode by *28*
2. Hit Copier
3. Hit Option
4. Hit ACC
5. Hit Out-Tray and set to a 1
6. Hit the OK button
7. Power the unit off/on with the main power switch on the right hand side of the unit.

Or, do you have an internal finisher built in?
If so check the Lower Limit Sensor PI9.
In case its faulty here is the part Number for PI 9 is WG8-5696-000.

[br21]

I found a solution. It was black piece of plastic missing which caused all the problems

[ennier]

Re: IR3100CN Show " Remove the paper from the output tray"

I found a solution. It was black piece of plastic missing which caused all the problems

friend could tell me what is that black piece of speech that I have the same problem and I throw final error 020 ..

[copier tech]

Re: IR3100CN Show " Remove the paper from the output tray"

friend could tell me what is that black piece of speech that I have the same problem and I throw final error 020 ..

Start a new thread & include the FULL error code eg. E020-XXXX