at gp 200 e803 error occur, i check dc board, which electronic component fault that dc board, i replace the dc board new one its work fine, but that faulty board what component we can change plz help me,
-
-
E-803
i don't think is Dc board faulty. If occur againt try to do the setting first under service mode<Function12<R&D SHANDING.Pls follow the procedure. Or check the both ends or the fluorescent lamp has blackened or not. If still cannot,then change composite power supply -
GP 200
Title : E803, lamp ends black. Error :
E803 code with both flourescent lamp ends black. Lamp settings were checked and correct. Lamp and composite power supply were changed.
Workaround :
Check the lamp cables, found one area where the wire was cracked open and shorting to the frame. Changed cable.Comment
Comment