If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
As part of a modernization of our layout, the Fax/Printer Forums are being merged into their respective brand channels under the main Copier Technical Discussion area.
If your favorite Fax/Printer channel isn't here, you should check there.
we have a canon ir2010f that requires a user id code entered to change settings.it will not go into simulation as the book states pressing the & key then pressing # id which does not work.what can be done to override this?
Comment