When put paper in dadf and pres start button, get message to remove paper form DADF.
There is no paper in DADF. Replaced all sensors in DADF but still same.
There is no paper in DADF. Replaced all sensors in DADF but still same.
-
-
Try initializing the sensors from service mode and reboot.
FEEDER>FUNCTION>SENS-INT>OK -
check n' review>
Sensor Holder does not come with the new PCB2 Sensor Unit and you would need to remove it from the old unit and snap it on the new unit. If misplaced, the sensor holder is available as a service part. The part number is: FC5-3131-000
Sensor..jpg
DADF..jpg
just to add on>0094 jam code:
At the start of operation the presence of an original has been detected by a sensor in the paper path. The sensors that generate the code are PCB2 the Post separation sensor pcb, PCB3 the Read sensor, PCB4 the Delivery/reversing sensor pcb.
Check / and inspect**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
Comment