canon lc 830i

[buzzmeok]

Hi I have a canon LC 830i and I am having jamming problems. The paper is picked up out of the cassette and stops intermittently at the registration roller. If I open up the back of the machine you can see the pick up gear turn and the registration clutch does not fire,Then the pick up gear will turn again and the clutch does not fire.and again then it will jam at the registration roller. This does not happen all the time. I can make any where from 1-50 prints and no jam. But when it does jam it will stop every time at the registration roller.
Parts replaced-
Pick up Rollers
Sep Rollers
Registration clutch
Torque limiter
Registration sensor and flag unit

any one have any ideas??

[SCREWTAPE]

Do you have a jam code??
That could help us help you.

What about wiring?
Cut any wire ties if there are any on the clutch.
Also check connectors on the dc.

[buzzmeok]

all wire ties are removed ill check for the rest today

[teckat]

all wire ties are removed ill check for the rest today

post the jam codes ??

Jam Codes (Main body)
0104 Pickup Delay Jam
0208 Pickup Stationary Jam
0210 Delivery Sensor Stationary Jam
0214 Stationary Jam.
021c Wound Paper Jam
1118 Door open Jam

Jam Codes (ADF)
0000 Unknown jam
0007 Initial stationary
0008 Document edge sensor
delay jam
0009 Document edge sensor
stationary jam
000c Delivery delay
000d Delivery stationary jam
0010 Pickup NG

[D_L_P]

you can see the pick up gear turn....Then the pick up gear will turn again and the clutch does not fire.and again then it will jam

If it tries 3x and still can't feed it will register a jam. It should be able to pick up the paper on the 1st try, if it has to try 2 or 3 times to get the paper your problem is in the feed section. I would try replacing the cassette, it could be cracked, the springs could be weak, the part that hits the sep release could be worn down. I've replaced cassettes on many fax machines especially ones with a lot of miles. If it does have a ton of copies the rails the cassette slides on can also wear down.

[buzzmeok]

It was the paper feed clutch

[teckat]

It was the paper feed clutch

if u need help/ Call
logo..png

[SCREWTAPE]

It was the paper feed clutch

What jam code was associated with that bad clutch?
This could help somebody in the future.

[buzzmeok]

could not find jam code

[teckat]

look in service mode images..jpg