canon wont go to ready.fuser heats up no error message . stays at please wait .
-
-
Check to see if the machine is out of staples. -
try disconnecting the Finisher. If the imageRUNNER will come to ready with the Finisher disconnected there may be a fault in communication with the Finisher, even though no error code is indicated.
Check to see if the Staple Cartridge is properly seated. It has been found if the Cartridge is not fully seated in the Stapler the above symptoms may be observed.
also check that the finisher has not run out of staples or the staple cartridge is missing or not properly installed.**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
-
no finisher to copierComment
-
performed 19 scan disk. also had boards out for adf .Comment
-
Normally something like this is related to the finisher which is why the other guys had you start there. You stated no finisher so go next and Check the fixing feeder frame connector. Also-is there paper behind the Fixing feeder frame assy? Have you checked the error history in service mode?Last edited by blazebusiness; 07-09-2010, 05:03 PM.sigpicAnything can be made to work if you fiddle with it long enough- San Diego Copier Repair.comComment
-
ribbon connector from optics loose . problem solved.thnxComment
-
Glad you are fixed !sigpicAnything can be made to work if you fiddle with it long enough- San Diego Copier Repair.comComment
-
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
-
me too stupid error on my partComment
-
How did the ribbon cable become loose?Canon Copier Repair Service. Sales, Parts & Toner. NYC/NJ area. Contact:East Coast Imaging Solutions,LLCComment
-
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
Comment