CANON IR330 DADF-A1 question

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • repn1999
    Trusted Tech
    250+ Posts
    • May 2010
    • 310
    #1

    CANON IR330 DADF-A1 question

    How do you get the DADF-A! to feed from the bottom instead of the top
    Tags: 152, 1999, 232, 328, 523, 999, bottom, canon, dadf, dipsw, doc, feed, ir330, light, off, one, procedure, reset, set, sharp, side, tech, time, top, tray
    • teckat
      Field Supervisor
      Site Contributor
      10,000+ Posts
      • Jan 2010
      • 16092
      #2
      Originally posted by repn1999
      How do you get the DADF-A! to feed from the bottom instead of the top



      are u a tech ????
      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • Herrmann
          Senior Tech
          Site Contributor
          500+ Posts
          • Jan 2006
          • 792
          #3
          Dipsw1, pos 4 and 6 set to *on*
          press pushsw3 one time, led1 should light up
          press pushsw2 5 times, now led2 should light up
          press pushsw3 one time, now led 2 should go dark
          set dipsw1 all to *off* position

          ----> done



          rem.: to reset the procedure, do the same, but press pushsw1 5 times in step3
          If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!

            Comment

            • repn1999
              Trusted Tech
              250+ Posts
              • May 2010
              • 310
              #4
              to respond to techat's comment.....yes i am a tech. I work on nearly 100 percent SHARP machines. We took on a few stray Canons because our biggest customer had no service on the few remaining machines they had and werent ready to upgrade them. thanks for the help.

                Comment

                • teckat
                  Field Supervisor
                  Site Contributor
                  10,000+ Posts
                  • Jan 2010
                  • 16092
                  #5
                  Originally posted by repn1999
                  to respond to techat's comment.....yes i am a tech. I work on nearly 100 percent SHARP machines. We took on a few stray Canons because our biggest customer had no service on the few remaining machines they had and werent ready to upgrade them. thanks for the help.


                  only reason I ask , Is because when we give instructions about dip switches it confuses end users & techs with little experience


                  hope herrmann helped u out
                  **Knowledge is time consuming, exhausting and costly for a trained Tech.**

                    Comment

                    Previous template Next
                    Working...