an irc 3100 shows an error e 070-02 I knw itz related wid IBT but plzzz brief me abt
-
-
Error code E070-0002. The time that passes after detection of the ITB home position to the next detection of the home position is longer than expected.
1. Check the Transfer Cleaning Assembly
2. Check for toner coating the ITB home position sensor.
Remove the ITB cleaning assembly and clean and adjust the cleaning blade side seals so that the seals touch the blade on both ends.
Reinstall and perform an ITB cleaning to verify that the seals are cleaning properly.
Replace the side cleaning seals if proper cleaning is not being performed (part number FL2-0084-000; Blade Sheet, front and FL2-0085-000; Blade Sheet, rear).
3. The ITB Belt should be between backup holder & PS19.**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
As well as previous reply check :
1 - Tension arms front and rear. These break.
2 - Home Position sensor - This can blow if belt has ripped. (Replace Complete assy)
3 - Earth Tags - If after replacing unit you still have error, check earth tags on rear frame.
Hope this helpsOh...... I can't copy at the moment then ? !!!!!!Comment
-
Or white patch is worn,dirty...at any rate,clean the rolls,contacts,sensor inside the assembly and put a new belt on it....machines are garbage....son of 6800Comment
-
where is d tension arm front & rear near itb
plzzz if any1 has a pic of where d tension arms are near d ibt plzzz send det pic or atleast describe it briefly it will b helpfulComment
-
as canuck said dis machine irc 3100 is not good is it d truth plzz all my seniors share ur views so i'll decide wwhether 2 sell dis model or notComment
-
error e070-02
hi ,
i face same prob ,and i found pcr was not properly installed in ibt unit ,or it is not getting current from hvt
just check it ,
bye
pramodComment
-
"Where are tension arms???"
With the ITB removed from the copier, remove the front and rear shields, held on by one screw each. Behind these are the tension arms and springs."Once a King, always a King, but once a Knight is enough!"
Comment
-
thnxxx all mission accomplished yeppeeee thnx 1c again every1Comment
-
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
-
i wanna to be a technical manManufacturer of copier and laser printer parts&consumables in China.Comment
-
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
-
One added note...make sure that the itb is not riding on top of black plastic guide...i see reps put the belt over the guide by mistake when replacing the belt....drags the belt downComment
Comment