IR 600 Clearing Fault Code

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Printboy_67
    #1

    IR 600 Clearing Fault Code

    Hello Board, I hope someone can help me, I am doing a buddy a favor for his old machine. The fuserweb needed replacing so I took care of it for him but I can't remember how to get to service mode to clear the e0005 fault. I hope someone out there will be kind enough to refresh my memory. It has been a while since I worked on a canon.

    Thanks in advance,

    Printboy_67
    Tags: 600, clearing, code, fault, help, old, refresh
    • ladybird
      Technician
      • Aug 2007
      • 29
      #2
      Do you mean IR6000? if so *28* (additional functions *) will get you into service mode. Then under functions>clear>err should get rid of the error code & you may possibly need to reset the web counter ( not that familiar with this machine)

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22744
          #3
          Same

          Same on iR600.
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            Previous template Next
            Working...