I have an HP M680 MFP in-house that I have fixed a 59.00.F0 error by cleaning the Alienation Solenoid of a sticky foam rubber pad that had deteriorated over time. When I rebooted the machine, the 59 code did not return. I ran a set of config pages successfully. However, when I ran a CYMK Samples page, it throws a 49.2F.D8 firmware error, and fails to use all colors, using only the black, and yellow, plus cutting off the last 1/4 of the print, and jamming as well. I updated the FW but to no avail. Any suggestions, hints, tips, or advice will be humbly appreciated.