[Misc] Low Security displayed on FS-3040+MFP

[Dyvyne]

Has anyone out there seen ''Low Security'' displayed on a FS-3040+MFP instead of ''Ready to Copy''? How do i clear it?

[MDR24]

Re: Low Security displayed on FS-3040+MFP

I've just had it on an FS-1135mfp. If its the same you need to go into system settings then security level its been set to low. The default is high.

[Dyvyne]

Re: Low Security displayed on FS-3040+MFP

Thanks for this. But on this model, i can't find the option of security level. Can you tell the steps to follow from System settings to locate this?

I've just had it on an FS-1135mfp. If its the same you need to go into system settings then security level its been set to low. The default is high.

[laitang]

Re: Low Security displayed on FS-3040+MFP

Thanks for this. But on this model, i can't find the option of security level. Can you tell the steps to follow from System settings to locate this?

System Menu/Counter key > System > Security Level

[Dyvyne]

Re: Low Security displayed on FS-3040+MFP

On the Kyocera FS-3040+, from the System Menu/Counter > System/Network > what you get is Network Setting, I/F block set and Restart. There is no Security Level as an option. Can you send a screenshot if you do have.
However, when i enter the Network settings, it is only Secure Protocol that is close to it, and the option doesn't provide for off and on

System Menu/Counter key > System > Security Level

[MDR24]

Re: Low Security displayed on FS-3040+MFP

I'd try resetting the entire device to default through the command centre if your at a dead end. Just make sure you get all relevant information from the machine before you do it.

Good Luck