[CQ] Pro 1107ex

[Guest]

Copies running light after a while. Replaced developer, New toner hopper , pipes all cleaned, and clear, toner supply motor New. Tones up after force toner supply . Did all the settings for light copies. Toner rate on 650.Also replaced development unit mag roller bearings. Development unit on 3 and a half million. Machine 21 million copies.Thanks Douglasc

[slimslob]

Re: Pro 1107ex

Try the following:

SP 2210 ID Sensor Pattern Interval change to 1
If happening during long print runs change SP 2506-001 to 1 and -002 50.

[eccelobo]

Re: Pro 1107ex

Replace the toner cylinder (the one before the pump). It happened to me and that was the solution.
Good luck!

Enviado desde mi SM-G920V mediante Tapatalk

[davel]

Re: Pro 1107ex

How are all PCU pm parts, I would think you may need to replace dev unit.

[Firoozshayan]

Re: Pro 1107ex

How are all PCU pm parts, I would think you may need to replace dev unit.

I think you should clear all the file in machine then send a new file and do print

[slimslob]

Re: Pro 1107ex

I think you should clear all the file in machine then send a new file and do print

What the fuck are you talking about idiot? This thread is over 3 years old, dead and was buried. Go away ghoulish grave robber.