Could anyone please teel me what error BK 069 is the paper gets to the staple area all ok the jogs paper then errors i cant find the cod in the manuale thanks in advance.
-
-
Re: BK5030 error BK069
found the info i needed in the pbm350 manual BK-069 Staple Detection Clinch Left Sensor BK-Q19 Short Circuit
This Fault code indicates that the Clincher is shorted to frame or GND.
Possible failures: - Staple or staplerhead is in contact with the clincher. - Short in sensor cable that goes to clincher BK-Q19 (PL 7.0).
Initial Actions Ensure that both Stapler Heads are in upper position. Ensure that Connector "Clinch Left" and "Clinch Right" are connected.
Ensure that Connector "J39 / P39" and "J40 / P40" are connected.
Ensure that Connector "A.P1" is connected.
Check all cables to above connectors are not damaged.
Procedure Disconnect plug A.P1 from CPU/Controller PCB "A". Measure between J1-24 and Chassis/GND (Signal and GND)
Replace CPU/Controller PCB "A".(PL 3.1) Disconnect plug "Clinch Left" Check white wire to A.P1-24 to frame.
Is there a short circuit Y N
Check J4 at Left Clinch to frame for short circuit. Is there a short circuit
Y N
Replace CPU/Controller PCB "A".
Replace Clinch Left (PL 7.0)
Replace/Repair Wire Harness.
Replace/Repair wire harness.
Comment