MP C2500 SC995

[Cipher]

Re: MP C2500 SC995

IF you only swapped the SD card over between MPC2500's it's probably a serial number mis-match.

[ameritech]

Re: MP C2500 SC995

I replaced the print card from an mp c2500 with one from a different machine, it fired up, then i switched the original print cards to the original machine. And now i am having a sc995 error code and it says that it is not the original controller board, but it is. So i tried reformatting the HDD with 5-853-001 and nothing is working. Still have the sc995 code, any suggestions?

SC995


[Cause]
The IOB is faulty.
[Resolution]
Replace the IOB.
When using an IOB that you removed from another device, refer to the notes below.
[IOB Replacement Notes]

• The new service parts AT-C1a/C1b can be used in common
• AT-C1a cannot be used with an IOB that AT-C1b is attached to
• AT-C1b cannot be used with an IOB that AT-C1a is attached to

[sandmanmac]

Re: MP C2500 SC995

GG shows this relating to your issue, but I don't have the TSB. Maybe someone else will weigh in on it for you:

SC 995

Controller mismatch error - see TSB# 003 "Technical Tips" #4 Swapping PCB's between machines

[ABS tect]

I replaced the print card from an mp c2500 with one from a different machine, it fired up, then i switched the original print cards to the original machine. And now i am having a sc995 error code and it says that it is not the original controller board, but it is. So i tried reformatting the HDD with 5-853-001 and nothing is working. Still have the sc995 code, any suggestions?