initial problem the transfer belt was tearing. replaced the transfer unit. a few days later i started getting the SC370-03 error. the first time it occurred i realized it happened after about 350 prints/copies ran according to the counter. i know the service manual points to the TM ID sensor. i have replaced that sensor and set the 6 values on each of the 3 sensors according to the service manual. i got the values off of the new sensor, which had them attached to each of the sensors shows the 6 values. i double checked myself to make sure i had the sensor turned the correct way before installing it. so i knew the F C and R of the sensors. then after install i entered the values according to the F C and R. i have noticed i could turn the copier off and unplug it. i can remove the transfer unit/module and blow the sensors off with air. then after reinstall and power-up it will work for a day or two. then i get the same error again. has anyone ran into this before? thanks for any help, it's greatly appreciated.
Bookmarks