I agree replacement of the screen is ultimately unavoidable but just a tip to run a thin ID card under & around the perimeter for any gunk.
I agree replacement of the screen is ultimately unavoidable but just a tip to run a thin ID card under & around the perimeter for any gunk.
JR2 suggestion is worth a try. Problem with OEM touch screen was the foil pattern lifting off board from heat. Back when I was working on these I must of replaced at least 50 of these touch screens. Once replaced with aftermarket never had to replace again. It was a poor designed OEM part. This was one case where the aftermarket was better than OEM !! And less expensive, Think the OEM touch screen was around $200 back then.
Funny story:
I had a billable customer that used his bizhub 200 only for printing, so when it had an error message (sorry, can't remember which) this customer expected me to install a new control panel only long enough to reset the error, then put that new panel back on my shelf at no charge. I found this request quite funny. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
He did not buy the panel. The story ends there ... because I don't know another ending. I'll guess that it was junked ... unless there's a tech stupid enough to do what he wanted. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Bookmarks