Thanks: 
Likes: Konica Bizhub 600 Network Not Working To Pc
Dislikes: 0
Konica Bizhub 600 Network Not Working To Pc
assuming you can ping the copier or access copiers web page
just click "The printer I want isnt listed"
then add a printer using ip address
To install a 600 print driver you want to use the "add printer" method and manually enter the IP address and use the .inf file.
the 600 needed the ic202 image controller to print if it is not there or damaged, maybe why you can't print.
Are you sure it has the printer chip installed for printing?
Print configuration page and it will show if installed
I noticed that one of the LEDs next to the network connector was blinking rapidly. Jabber like that could means that the connection is being hammered. It could be the network interface in the Bizhub or it could be the switch/hub/router that it is connected to. Try connecting directly to your laptop. If you still get jabber it is most likely the Bizhub
s-l400.jpgOriginally Posted by K-3
I tried to replace this this card from working machine but no luck
The IC 602 was a 8 pin EEPROM looking device..I'm not sure what you are showing...Out of the box it was a copier/scanner..No printing without the IC..E
Looks like IROM if there is a battery on the back its the NVRAM. I would suggest putting back the original one.
Whatever
After watching the video again...This is a pretty old machine..If the network card is configured to auto negotiate, it may never connect to a 1gb port.try setting the port to 100 full duplex. If this is a DHCP environment try restarting in DHCP and see if you can pull an address. Another thing would be to go into Admin and turn OFF TCP/IP , cycle power, then turn TCP/IP on. this is like a NIC reset. Also..someone refresh me..did the 600 need a x-over to connect directly back to a laptop? E
Posting Permissions
Reply With Quote
Bookmarks