I have a Pro 8210
With a code SC513-11, has anyone seen this issue before,
So any help would be appreciated
Thank you
I have a Pro 8210
With a code SC513-11, has anyone seen this issue before,
So any help would be appreciated
Thank you
Last edited by toddanderson; 04-23-2021 at 09:15 PM.
If you have no formal training on Ricoh Production models you should not be trying to work on them.
On a production machine you will better of calling a credited ricoh production engineer you could doing more damage than good.
Regards Mark
FOR TRADE AND END USER SERVICE CALLS PLEASE VISIT WEB SITE FOR CONTACT DETAILS. COVERING GREATER LONDON {UK} AND ALL SURROUNDING COUNTIES.
RICOH, CANON, KYOCERA, KONICA, SHARP, HP/SAMSUNG BROTHER, LEXMARK.
https://copierservices.simdif.com
check drawer unit connectors on rear machine right side facing from front. have had 4 machines throw this code and every one was a 82xx model ad they all had broken connectors on the either the main frame side or drawer unit side. or both. idiots slamming the drawer unit back in really hard or an obstruction blocking the contacts usually will do it.
For what it's worth...
- Code: SC513-11
- Description: Trailing edge shift unit HP sensor error 1: Initialization
- Causes: Normally, the shift unit HP sensor goes ON within 20 pulses after the trailing edge shift motor starts to rotate cw; however, The HP sensor did not go ON within 20 pulses after the motor started to rotate cw. The HP sensor did not switch from ON to OFF within 67 ms after the trailing edge shift motor started to rotate either cw or ccw.
- Remedy: Trailing edge shift motor harness loose, broken, defective HP sensor harness loose, broken, defective Motor overload due to blockage Motor driver defective Sensor defective
This is for the Pro 8110 though...
Bookmarks