C454e printouts are wavy.

[Albonline]

Well I tried newer one. Still does that wavy half of the paper.
Forgot to mention that when printing on both sides of the paper, the whole page is wrinkled or wavy.

I have only had 1 ever go bad, but what about the motor that drives the reverse unit?

[Barry97]

I have only had 1 ever go bad, but what about the motor that drives the reverse unit?

Well I replace the reversal unit with another one from a 554e.

Can not find the issue with this.

[tsbservice]

Print out is wavy. Tried changing the paper and replaced the fusing unit for a new one.
Tried adjusting the temperature and the fusing speed.
Cleaned the rollers.
Replaced the fusing drive.
Replaced the exit and reverse section.
Still the papers come out wavy.
This happens on all format sizes.

Seems like this happens after the fusing unit.

Running out of options.

It may sound silly but can you run it for a test without reverse section(I mean top section on right door)?

[Barry97]

It may sound silly but can you run it for a test without reverse section(I mean top section on right door)?

Caused a paper jam.
Still the fuser is causing the wavy page.

[Barry97]

It may sound silly but can you run it for a test without reverse section(I mean top section on right door)?

Is there any possibility if the frame is bent?

[Albonline]

Is there any possibility if the frame is bent?

is the feed loop sensor damaged?

[Barry97]

is the feed loop sensor damaged?

Ran the sensor check. Looking at the Paper exit in service mode. The fusing loops value remains at 0.

Can the cause the paper to be wrinkled/wavy?

[Albonline]

Ran the sensor check. Looking at the Paper exit in service mode. The fusing loops value remains at 0.

Can the cause the paper to be wrinkled/wavy?

yes registration clutch stays on until loop sensor is made. this issue is more prevalent in the 654/754 series but this unit shares same basic operation.

[Barry97]

yes registration clutch stays on until loop sensor is made. this issue is more prevalent in the 654/754 series but this unit shares same basic operation.

So there must be a synchronization issue with two units?

[Albonline]

So there must be a synchronization issue with two units?

yes that is one of the functions of the loop sensor