Activity Stream

Open the right door inside the machine is a metal roller below the registration on the left side of this roller is a leaf spring check this is in...

Oh so he is one of them, only accepts the worst predictions.

I am 100% sure, i check sc histoty everytime when that is hapened.

Dr. Fauci warns US may not return to ‘normalcy’ until 2022

Are you absolutely positive that there were no Service Codes. It could be a Level C Service Code. SCs that are not shown on the operation panel. They...

Has he actually said that on TV or is it reported that he suggested that. The press over here prints any garbage so so long as they claim "its...

Service Mode Imaging Process Adjustment Manual Toner Add But first I would like to see: State Confirmation Level History 1 Level History 2 ...

I check that when i first time got that priblem, everting is ok, Problem is fixed for 100k when i put another polygon motor, but i cant figure what...

May help Canon Copiers - MIB monitoring - THWACK

* Ahem * :) Hans

�� I believe CP is a check pin on the Board, could be a small depression or actual pin or something that looks like a small female plug. Look on...

Lets start out easy. Paper size in the regular trays is auto detected using sensors inside the copier and is based on the position of the paper...

Where that paper is being pulled from, there should never have paper there. It should be going down into the slot that is on the right side of those...

Yes, from a USB drive. I've yet to see a bulletproof copier. ;)

just print from a usb drive? Yes calibration huge mystery to many of us ! Also on my mind a question: Heres the latest Kyocera out in...

I thinks you should replace whole of right door, not only transfer roller.

OK thanks so much BC...:D Am i correct here? .. the 32xx is low speed model design.. (32ppm is top speed for that model) . and the 35xx is the...

error code 093 is most I have found on site 100% from R1 area , toner all over that. just vacuum it until u can move gear easy with your hand. if...

Set the network speed to 100 speed duplex. I find most routers now autonegotiate the speed. Modern nic cards in copiers do the same. Sometimes...

Does it have the latest and greatest firmware? Any CFA14 or CE301 in the history? Have you done self diagnostics on it?

Unfortunately too many people ask for help but then don’t reply when they’ve solved it or given up. It would be nice to get a follow up. Sent...