Activity Stream

If the procedure is correct, you probably have a software problem, try to reset and update the firmware. Have you tried on the web page?

Thank you very much for the clarification. My man sent me the drums without this modification (only the chip change) and I didn't want to sent them...

Found it paddle senors on the inside of the finisher sit on a metal plate that isn't part of the frame. The metal had popped out... Funny cause I...

I have noticed version release dates do vary across the pond (usually you guys are ahead!)

What's about magenta on the left side?

Interesting. Both the Ricoh-USA and the Ricoh Global pages for the M C250FWB under firmware only show Machine Controller Firmware Ver.1.08 Dated...

Oh, sorry for doing that then...

Thank you for all the advice, i will give feedback on my findings.

Update the firmware to version Engine Ver.1.01:02 & MAIN-PDL Ver.1.09 (released 2021/04/23) Turn on DHCP let the device pull correct network info...

The 121.04 error problem is solved as follows: 1. Replace the fuser that gave the error with a new one. 2. From the Lexmark x950 enter the mode:...

Code: C3102 Description:Heating roller failure to turn. During any state other than printing operation, the hard latch signal from one or both of...

Last post of the night. This is random and only my personal opinion. Here's what's surprised me the most thus far. 1. Layer 4 of the OSI...

If the cyan drum is near or beyond life, replace that at the same time as the dev unit, or you may drain your new unit. Has happened to me a couple...

I didn't see it mentioned previously, but have you tried adjusting the height of the ADF? If the white platen sheet is too close to the glass, it...

The differences aren't visible in your picture. If you are trying to use a black drum in place of a color drum, then the black end piece needs to be...