View Full Version : BH 423 SKEW TRAY 1 ONLY.
splblazer91
07-16-2015, 04:13 AM
A fellow tech has been fight this for a while. prints fine out of all other trays but tray 1 skews the prints. He has replaced all rollers and clutches and the feed guide for tray 1. Still doing it. Any suggestions?
Phrag
07-16-2015, 04:51 AM
Is there any folded corners on the bottom of the paper stack?
Sent from my GT-I9506 using Tapatalk
allan
07-16-2015, 06:14 AM
I have heard the hinges on the machine can get bent affecting tray 1 only. I have one of those machine it's got a LCC on so i gave up on it and set the tray priorities to the other two trays.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.