darry1322
08-05-2015, 07:46 PM
"ronpfid
2 Attachment(s)
Bizhub C350 / Poor copies, good print
This one acts like it just can't calibrate it's gradient right...
Prints good, but when you copy something, it reads/prints lighter areas poorly. Like it's calling light colors as not there.
Printed a test page, looked good, but when copied, looks like this, looks same on glass or in adf.
Ran gradient calibration twice, no change. Any thoughts?
When you use the word print in the subject line the board software formats your post in a printable view which keeps others from answering.
Make sure your optics are clean then run the Gradation adjustments.
2 Attachment(s)
Bizhub C350 / Poor copies, good print
This one acts like it just can't calibrate it's gradient right...
Prints good, but when you copy something, it reads/prints lighter areas poorly. Like it's calling light colors as not there.
Printed a test page, looked good, but when copied, looks like this, looks same on glass or in adf.
Ran gradient calibration twice, no change. Any thoughts?
When you use the word print in the subject line the board software formats your post in a printable view which keeps others from answering.
Make sure your optics are clean then run the Gradation adjustments.