View Full Version : How to setting Ysoft card reader.
sangcom
08-12-2015, 06:19 PM
Hi all
After install loadable driver.
How to setup Ysoft card reader on bhc3350?.
Thank you
allan
08-12-2015, 06:27 PM
You have to change have to switch on the card vendor mode i think it should be on "Card 2". Its normally under billing mode.
On this machine i am not sure how to get there on that machine. Did you try "Stop" "9" from the service screen.
I know the entry methods was changed on this model.
Does someone know?
sangcom
08-12-2015, 06:40 PM
You have to change have to switch on the card vendor mode i think it should be on "Card 2". Its normally under billing mode.
On this machine i am not sure how to get there on that machine. Did you try "Stop" "9" from the service screen.
I know the entry methods was changed on this model.
Does someone know?
I can't found card 2 in billing mode (stop 22200)
thank you
allan
08-12-2015, 08:49 PM
Hope someone knows. Have you tried the manual i don't have it yet.
It's always fun making AU's work.
B0265
08-13-2015, 07:44 AM
Log in as administrator in the web interface. You will find authentication device settings under the security tab.
wseyller
08-14-2015, 04:10 AM
We use the AU-201H and AU-205H. On this model C3350 we only install the loadable driver. No need for anymore settings. Reboot and it should work just fine.
Sent from my XT1254 using Tapatalk
sangcom
08-24-2015, 03:42 PM
We use the AU-201H and AU-205H. On this model C3350 we only install the loadable driver. No need for anymore settings. Reboot and it should work just fine.
Sent from my XT1254 using Tapatalk
-------------------
Thank you
It's work
tonyligz
10-06-2015, 01:54 PM
Hello, I need SafeQInstant3.6.2 license , please send to 405173825@qq.com. I Willing to pay, thank you!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.