Bizbub 601 jam

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • JALAL
    Junior Member
    • Oct 2014
    • 4
    #1

    [Jamming] Bizbub 601 jam

    Hi everyone,

    I have a bizhub 601 machine start jamming papers suddenly on the vertical conveyance door from trays 2,3 and 4.
    I looked around and found that vertical conveyance clutchs CL11 and CL12 don't turn on (tried to replace them but no luck), so the vertical conveyance rollers 1-3 don't move and paper jam.
    any ideas please.

    JALAL
    Tags: None
    • 3boydad
      Technician
      • Aug 2015
      • 27
      #2
      Re: Bizbub 601 jam

      is it jamming all through the machine? check ADU the mylars stick in paper path. hard to see them but they will do that. Fuser causes a lot of jams. does it jam every copy? try isolating the issue. leave the jams in and look real close. it will show its ugly head.

        Comment

        • Downunder
          Trusted Tech

          100+ Posts
          • Aug 2007
          • 174
          #3
          Re: Bizbub 601 jam

          ICB's on the print board might have blown due to drum pawl solonoid wires shorting out on the main rear drum bearing.

          Remove the drum carriage and check the wires from the drum pawl solonoid -- they will probably have been squashed against the main bearing on the drum shaft. After you have rectified this you will need to either replace two of the ICB's or print control board.

          Good luck.

            Comment

            • EarthKmTech
              Step aside, noob

              1,000+ Posts
              • May 2009
              • 2139
              #4
              Re: Bizbub 601 jam

              Originally posted by Downunder
              ICB's on the print board might have blown due to drum pawl solonoid wires shorting out on the main rear drum bearing.

              Remove the drum carriage and check the wires from the drum pawl solonoid -- they will probably have been squashed against the main bearing on the drum shaft. After you have rectified this you will need to either replace two of the ICB's or print control board.

              Good luck.
              Yep, been there done that, wont do it again

              Gotta make that mistake at least once to learn from it

                Comment

                • JALAL
                  Junior Member
                  • Oct 2014
                  • 4
                  #5
                  Re: Bizbub 601 jam

                  Originally posted by Downunder
                  ICB's on the print board might have blown due to drum pawl solonoid wires shorting out on the main rear drum bearing.

                  Remove the drum carriage and check the wires from the drum pawl solonoid -- they will probably have been squashed against the main bearing on the drum shaft. After you have rectified this you will need to either replace two of the ICB's or print control board.

                  Good luck.
                  Thank you Downunder, I will try this soon.

                    Comment

                    Previous template Next
                    Working...