glimmer1980
09-28-2015, 01:33 PM
Hello,
About two months ago i replaced the imaging unit of a ML-6515 because of the message "calibrating image density". They received this message every couple of prints and the message took about 20 sec to disappear....rather annoying if your waiting for your print. So after replacing it worked fine. Last week i received an email and they have the same problem again.
The remaining imaging unit is at 94%, see image
30775
Has anyone experienced this problem before?
Kind regards,
Ramon
About two months ago i replaced the imaging unit of a ML-6515 because of the message "calibrating image density". They received this message every couple of prints and the message took about 20 sec to disappear....rather annoying if your waiting for your print. So after replacing it worked fine. Last week i received an email and they have the same problem again.
The remaining imaging unit is at 94%, see image
30775
Has anyone experienced this problem before?
Kind regards,
Ramon