paulrid
12-30-2015, 01:27 PM
31601
Hi all,
i have a c203 which is producing lines on prints as per attached, you can can see them on the demo page under the box with text, around the 20% and 70% and also on the config page. The lines are not in the feed direction but accross it. The machine was fine when tested but after it was moved up a flight of stairs this happened. So far i have changed black IU transfer belt and secondary transfer roller and even fuser with not effect. I have stopped a demo page while printing and can't see the lines on the image on the ITB. I have adjusted many setting in tech rep but no difference, have anyone seen this before or any ideas?
thanks Paul.
Hi all,
i have a c203 which is producing lines on prints as per attached, you can can see them on the demo page under the box with text, around the 20% and 70% and also on the config page. The lines are not in the feed direction but accross it. The machine was fine when tested but after it was moved up a flight of stairs this happened. So far i have changed black IU transfer belt and secondary transfer roller and even fuser with not effect. I have stopped a demo page while printing and can't see the lines on the image on the ITB. I have adjusted many setting in tech rep but no difference, have anyone seen this before or any ideas?
thanks Paul.