View Full Version : pro 951 7229 jam
splblazer91
02-04-2016, 01:23 AM
Paper stops in finisher transport section going to the bottom output tray. If i push everything to the top tray it runs fine. Tech support had me order 2 motors but i doubt that will resolve the issue. Any ideas?
antone
02-04-2016, 02:17 AM
Try looking for solenoid gate
splblazer91
02-06-2016, 04:49 PM
Solenoids seem to function properly. Replaced entrance and exit motor. Still jams.
chucko71
03-10-2016, 01:56 AM
I am also getting this same code on a bh951, J7229 code and stopping in the finisher mostly right after the hole punch unit. Was there a solution to this problem, Ive already tried multiple solutions from the call center with no luck. I can run about 200 or so copies before the first jam then its pretty consistant after that. Also feeding to the top exit tray seams to work fine.
Haroldbfix
04-27-2018, 04:23 PM
Paper stops in finisher transport section going to the bottom output tray. If i push everything to the top tray it runs fine. Tech support had me order 2 motors but i doubt that will resolve the issue. Any ideas?
Its been some time since the original post. What did you come up with on this problem. I have a similar issue.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.