PDA

View Full Version : CQ C-452 magenta problem


Custom Search


chivozx
03-03-2016, 05:40 PM
Hello, the imaging unit magenta toner developer and spits the bottom of the unit.
I tried it with another developer station and follows the failure.
The drum is new, the charging unit cleaned it and have tried with another.
I changed the density values and charge from the technical mode without any result.
I'm desperate, I hope your advice.
Greetings.
32089
####============================####

Hola, la unidad de imagen magenta escupe revelador y toner por el fondo de la unidad.
He probado con otra estacion de revelado y sigue el fallo.
El tambor es nuevo, la carga la limpio y he probado con otra.
He cambiado los valores de densidad y cargas desde el modo tecnico sin ningun resultado.
Estoy desesperado, espero vuestros consejos.
Saludos.

allan
03-03-2016, 06:39 PM
Did you rebuild the imaging unit?

chivozx
03-03-2016, 07:10 PM
Yes, but with another original development unit it do the same. A tot of develop and toner spits

allan
03-03-2016, 07:16 PM
Is that on the front of the unit?

chivozx
03-03-2016, 07:19 PM
No, the problem is on the bottom of unit

allan
03-03-2016, 08:01 PM
change the Imaging unit with a new one. There is a seal that breaks on the waste port that would drop toner on the front side of the unit when you rebuild it.

chivozx
03-04-2016, 03:22 PM
Is this piece you mention?
32103

allan
03-04-2016, 10:43 PM
Looks like it.
I don't rebuilding these units. They are toast at the end of the 3de cycle and will damage the drive if over run. Replacing it will fix your problem. Are u sure its not the drum??

chivozx
03-05-2016, 09:13 PM
The drum is new, no wear. It may come wrong, but all the developer falls into the gears

Custom Search