PDA

View Full Version : Biz 420 C3201


Custom Search


Gab
03-27-2016, 01:48 PM
Fuser motor looks good (it rotates) . Ca it be this motor? Also is there a way to check controller if this error comes from him?

minimerlin
03-27-2016, 01:56 PM
Fuser motor looks good (it rotates) . Ca it be this motor? Also is there a way to check controller if this error comes from him?Have you tried turning the fuser by hand? It is possible for it to seize up the bearings.:cool:

allan
03-27-2016, 06:05 PM
Load check code 40 Mulit code 1, 2 and 3 for the 3 speeds the motor can run at.
The motor send back pulses and the printer control board or motor board checks the frequency of the returned pulses.
So it could be a stiff fuser a bad motor or a bad control board.

My money is on the motor.

Custom Search