PDA

View Full Version : Jams 72 19


Custom Search


antone
04-18-2016, 10:59 PM
BH 1050....finisher jams in entrance ps 4 ..stops under senor I/0 mode used any usefull...tricks

Sent from my SM-N920V using Tapatalk

Mick01
04-19-2016, 07:00 AM
Hi,
So I assume that you mean by I/O you have checked that the sensor is changing state? It would be a good idea to also clean/replace the sensor as it may be intermittently faulting.

If so then it most likely is a drive issue (paper not making it past the sensor in time). Check and clean the conveyance rollers. Check the drive system,motors etc. Observe the drive operating when prints are being run to see if any drive issues are apparant.
good luck, hope this helps.

antone
04-19-2016, 07:23 PM
Hi,
So I assume that you mean by I/O you have checked that the sensor is changing state? It would be a good idea to also clean/replace the sensor as it may be intermittently faulting.

If so then it most likely is a drive issue (paper not making it past the sensor in time). Check and clean the conveyance rollers. Check the drive system,motors etc. Observe the drive operating when prints are being run to see if any drive issues are apparant.
good luck, hope this helps.
Ok will do.....very hard to tell seams like it's OK

Sent from my SM-N920V using Tapatalk

Custom Search