PDA

View Full Version : Miscellaneous BIZ hub Press 1250


Custom Search


IMOT2000
06-09-2016, 10:32 AM
Hi there,
I have a Problem with a Press 1250 from KM. I`ve changed Drum, Developer and the Corona Wires, but i also have a low density
the resolution of the paper type is normal and the IDC Sensor is clean.
any ideas???

blackcat4866
06-10-2016, 01:20 AM
How many copies?
Did you do any of the drum peculiarity adjustments?

=^..^=

allan
06-10-2016, 05:29 AM
Past 6Mil the transfer belt contacts gets worn out. Yield is 4 Mil on those.

Then there is the toner agitator plates they last 4 Mil the yield there is 2.

kenpio
06-10-2016, 09:16 PM
had a BH951 doing the same thing, had less than 1 mil on it. I changed the high voltage sensor for the drum. Have not heard from the customer about that problem. Hope this helps.

KEN

allan
06-12-2016, 03:09 PM
had a BH951 doing the same thing, had less than 1 mil on it. I changed the high voltage sensor for the drum. Have not heard from the customer about that problem. Hope this helps.

KEN


That sensor should not get any kind of attention no air no vacuum and no cleaning.

Custom Search