C1060 with IC415, Centering Issue

[copytechman]

Almost brand new (15k!!!) c1060, Internal test prints line up fine when doing the auto centering or centering functions in service mode but when you copy or print the entire image is shifted to the rear by a good 1/4 inch or so. All trays doesnt matter. Tried dip switches and anything else I could think of..

Any assistance appreciated!

Regards!

A.

[Tech Helpdesk]

Almost brand new (15k!!!) c1060, Internal test prints line up fine when doing the auto centering or centering functions in service mode but when you copy or print the entire image is shifted to the rear by a good 1/4 inch or so. All trays doesnt matter. Tried dip switches and anything else I could think of..

Any assistance appreciated!

Regards!

A.


Try this guide !!

[copytechman]

Try this guide !!

Thanks! Turns out this one was a turd, looked upon further inspection that someone previously had mangled the image board connectors some. Not sure what else went sideways. Ultimately its now been relegated to parts status and has been replaced.

Regards!