mdtrinh
10-21-2016, 05:54 AM
I came across with this problem that I could not figure out what was wrong???
I done with about 10 Bizhub C451s (Konica & OCE mix), 8 units worked as it should be, replace IUs message gone, only with warning oil can.
- All with same latest firmware.
- Unit life -> unit change -> drum=service.
- Unit life stop setting -> supspend.
- No stop.
- SW 50 to 1 (black ready acs).
2 out of 10 units were not able to turn off replace IUs message, I even re-flashed firmware, change setting to opposite setting then set it back (power cycle after each setting), but no luck. The 10th unit done today with no problem.
Any idea???
I done with about 10 Bizhub C451s (Konica & OCE mix), 8 units worked as it should be, replace IUs message gone, only with warning oil can.
- All with same latest firmware.
- Unit life -> unit change -> drum=service.
- Unit life stop setting -> supspend.
- No stop.
- SW 50 to 1 (black ready acs).
2 out of 10 units were not able to turn off replace IUs message, I even re-flashed firmware, change setting to opposite setting then set it back (power cycle after each setting), but no luck. The 10th unit done today with no problem.
Any idea???