copycommerce
07-17-2008, 11:13 AM
Hello ,
i have a Di 450 with controller,scan board,upg.memory and hard drive.When i put the machine on the sensor for the hard lightes green and that means that the machine recognize it,but still i can't either format it or check it.In service mode in function when i sellect hard drive ON it gets a code.The question is what can cause the machine first to recognize the hard and then to not make a connection with it?Do i need to place the "jumper" on some specific slot(now is at the first).Any ideas are welcomed :)
i have a Di 450 with controller,scan board,upg.memory and hard drive.When i put the machine on the sensor for the hard lightes green and that means that the machine recognize it,but still i can't either format it or check it.In service mode in function when i sellect hard drive ON it gets a code.The question is what can cause the machine first to recognize the hard and then to not make a connection with it?Do i need to place the "jumper" on some specific slot(now is at the first).Any ideas are welcomed :)