DigiMan
11-02-2016, 10:17 AM
Goodmorning everyone!
Have this 1060L,as soon as it starts adjusting 2703 pops.
Inspecting it inside the cyan drum is covered in toner and the transfer belt at that very spot as well(covered in cyan toner).
Client said the day before there where 2 power failures one after another almost instantly,after opening close main power the machine worked a bit
then started popping the code.
Changing the cyan corona with another wielded nothing.
Changing the drum with another did nothing.
Inspecting the belt the cyan transfer roller seems fine and not out of place/dirty contacts.
Am i looking on an HV/1 board here?
Have this 1060L,as soon as it starts adjusting 2703 pops.
Inspecting it inside the cyan drum is covered in toner and the transfer belt at that very spot as well(covered in cyan toner).
Client said the day before there where 2 power failures one after another almost instantly,after opening close main power the machine worked a bit
then started popping the code.
Changing the cyan corona with another wielded nothing.
Changing the drum with another did nothing.
Inspecting the belt the cyan transfer roller seems fine and not out of place/dirty contacts.
Am i looking on an HV/1 board here?