View Full Version : 7 Series Paper Tray Size Recognition Issues
CraigW
11-18-2016, 01:28 PM
Anyone else seeing paper size detection problems on color & mono 7 series machines.
In the cassettes. 1 had letter loaded and said 5.5 x 8.5 the other was 11 X 17 and had ?? marks displayed.
Also had problems with the mono 7s cassettes as well.
Found a few solutions but not much info as of yet.
Thank You !
copyrooks
11-18-2016, 08:18 PM
I have run into this issue on many bizhub 227s and c227s. Usually the 2 screws on the tray need to be adjusted and it works after. I read a bulletin about an issue at the factory where they werent set correctly. I havent seen the issue comeback once adjusted. Hope this helps
blackcat4866
11-18-2016, 11:28 PM
I have run into this issue on many bizhub 227s and c227s. Usually the 2 screws on the tray need to be adjusted and it works after. I read a bulletin about an issue at the factory where they werent set correctly. I havent seen the issue comeback once adjusted. Hope this helps
I'm interested. Which two screws? Pictures please? =^..^=
copyrooks
11-19-2016, 01:46 AM
I attached the pdf for it
CraigW
11-21-2016, 01:46 PM
A few have worked after centering the screws.....some have not.
Those star washers remind me of fixes I used on 7020 series cassettes.
tech51
11-21-2016, 06:53 PM
Also the wiring to the sliding block on the rear can break causing size errors.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.