habik
11-20-2016, 08:25 PM
Had a cartridge stuck and couldn't get it out by turning the clincher mechanism both ways. So to release it I used a piece of mylar to stick it under.
First you pull cartridge out to the max, then slide the mylar under cca 70mm then push the cartridge with the mylar together all the way in cca 80mm then slide out as usual. See pic below
The culprit is the feed tong that wont remain in the "No feed position"
http://uploads.tapatalk-cdn.com/20161120/919673485edfa323b1000c20199ff8b3.jpg
Byting on bits.
First you pull cartridge out to the max, then slide the mylar under cca 70mm then push the cartridge with the mylar together all the way in cca 80mm then slide out as usual. See pic below
The culprit is the feed tong that wont remain in the "No feed position"
http://uploads.tapatalk-cdn.com/20161120/919673485edfa323b1000c20199ff8b3.jpg
Byting on bits.