View Full Version : Error Code "Fusing plug missing "
slytukana
01-22-2017, 10:03 PM
I try removing and fitting the riser but nothing change.
Attach is what appears in the panel
https://uploads.tapatalk-cdn.com/20170122/77e8cf8d0aa1bae60eb9f0e0cfc458cf.jpg
Thanks in advance for your assistance
Sent from my HUAWEI RIO-L01 using Tapatalk
blackcat4866
01-23-2017, 12:31 AM
It might be pertinent to know what model that you're considering.
But just on the most basic level, there isn't any power to one of the power plugs. Find out why. =^..^=
slytukana
01-23-2017, 03:03 AM
It might be pertinent to know what model that you're considering.
But just on the most basic level, there isn't any power to one of the power plugs. Find out why. =^..^=
It's a Konica Minolta bizhub 654
Sent from my HUAWEI RIO-L01 using Tapatalk
Synthohol
01-23-2017, 03:38 AM
i take it this is not a U.S. machine? there is only a single 20A plug on the U.S. models.
slytukana
01-23-2017, 11:17 AM
To be more specific it's a bizhub 654 .The machine has only done a 105 prints it was working well but as been not in use and switched off for some months and recently I try switching it on and it came up with the error "Fusing plug missing"
Sent from my HUAWEI RIO-L01 using Tapatalk
jrn821
05-22-2018, 07:25 PM
Hi, Has anyone solved this? Ran into same problem today. Cant find any Information regarding it. Thanks
dlandry
09-11-2019, 07:55 PM
Hi, Has anyone solved this? Ran into same problem today. Cant find any Information regarding it. Thanks
I am having the same problem after doing an all clear for a c163. My take on it would be that the machine is confused and thinks its a model with a separate fuser plug.
I figure a good place to start would be to set the correct time and time zone. This machine will only show tab number 8 Device information so not able to put correct time.
what I ended up doing was turning off smart fusing control under system 2 in service mode.
jrn821
09-11-2019, 08:33 PM
I am having the same problem after doing an all clear for a c163. My take on it would be that the machine is confused and thinks its a model with a separate fuser plug.
I figure a good place to start would be to set the correct time and time zone. This machine will only show tab number 8 Device information so not able to put correct time.
what I ended up doing was turning off smart fusing control under system 2 in service mode.
Ran into this again. Latest firmware resolved
tsbservice
09-11-2019, 08:37 PM
Ran into this again. Latest firmware resolved
Why not replied into this thread if FW resolve but now?!?
Walterj
09-12-2019, 04:23 AM
I try removing and fitting the riser but nothing change.
Attach is what appears in the panel
https://uploads.tapatalk-cdn.com/20170122/77e8cf8d0aa1bae60eb9f0e0cfc458cf.jpg
Thanks in advance for your assistance
Sent from my HUAWEI RIO-L01 using Tapatalk
good day
Dears
The error mentioned usually happens when the NF1 board is damaged
It is possible to repair it you have to have some knowledge in electronics
Greetings
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.