MVPunisher
01-25-2017, 01:35 PM
So kind of weird one here. I have 2 bizhub 951s next to each other. The one on the left started coding out with c2234. I started by replacing the to 2 photo sensors for transfer belt retraction as everything mechanically seemed to be functioning.
The sensors didnt fix it. I then swapped the transfer belt to the right machine and the right machine then coded. Ok it is in the transfer belt. I swapped the levers (one was gouged out pretty good) and the springs that ride on the retraction cam. That also did not fix it. At this point the belt is back in the left machine and that one is coding out.
Now... 9,000 prints later the right one decides to code out now...both machines are coding out. Seems environmental but what could possibly be environmental about this type code.
I am heading over with the motor today , just really thrown off by both of these machines doing this now.
Posted from a phone, not checking spelling...
The sensors didnt fix it. I then swapped the transfer belt to the right machine and the right machine then coded. Ok it is in the transfer belt. I swapped the levers (one was gouged out pretty good) and the springs that ride on the retraction cam. That also did not fix it. At this point the belt is back in the left machine and that one is coding out.
Now... 9,000 prints later the right one decides to code out now...both machines are coding out. Seems environmental but what could possibly be environmental about this type code.
I am heading over with the motor today , just really thrown off by both of these machines doing this now.
Posted from a phone, not checking spelling...